![]() So, I tried pressing Fn+F5 to see the status of the radio. If I click on the signal bars to connect, the list never populates with any access points. Basically, it's detected and everything, but when I go to the adapter settings page, there is a red X over the signal bars and it reads "Not Connected". So, I pulled my wifi card from port 2 and moved it to port 1 and it no longer works. The thing is, I plan to purchase the hardware, which would include the software, but I don't know which hardware I need, yet, and I don't want to spend $25 to get something that I'll end up getting for free later. I'm pretty sure I could accomplish this testing using the DIYeGPU Setup software that I've read about, but it seems that it costs $25 if you buy it without hardware. Ideally, I'd like to do some testing before I purchase any hardware, as I'll need to know whether I need to buy 2 mPCIe adapters or 1 mPCIe and 1 ExpressCard. Because of this, I'd rather use ports 3+4 for the PE4H, but I understand that if I set ports 3+4 to x2, ports 1+2 get changed to x2 as well, and that may cause my wireless card to stop working, even if I moved it to port 1. My laptop's wireless card is currently on port 2. I understand that I'll either need to use ports 1+2 or ports 3+4. I want to use the PE4H to run my GTX 570 at x2. I don't know where port 5 is, but it doesn't matter in this case. Ports 1, 2 and 3 are mPCIe and port 4 is ExpressCard. I have a Lenovo T61, which has 5 PCIe ports. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |